Details
| D | Diameter of cutting edge | 5,00 +0/-0,02 | |
| Cr/r | Corner radius/Radius | 2,50 | |
| l | Cutting length | 5,00 | |
| l1 | Neck relief length | 35,0 | |
| a | Neck relief depth | 0,10 | |
| L | Overall length | 105 | |
| d | Shank diameter | 6,00 h5 | |
| Z | Number of flutes | 2 | |
| Rif. gambo | Shank references standard | HA | |
| Coating | Balinit® Tisaflex | HMH | |
Materials
P.0 Low Carbon Steels, Long Chip (<120 HB)
P.1 Low Carbon Steels, Short Chip (<120 HB)
P.2 Medium and High Carbon Steels (<220 HB)
P.3 Alloy Steels, Tool Steels (600-850 R N/mm²)
P.4 Alloy Steels, Tool Steels (850-1400 R N/mm²)
P.5 Ferritic, Martensitic, PH SS Steels (600-900 R N/mm²)
P.6 Ferritic, Martensitic, PH SS Steels, Hardened (900-1350 R N/mm²)
K.1 GG Grey Cast Iron
K.2 GS Ductile Cast Iron
K.3 GS Ductile Cast Iron, Hardened
M.1 SS Stainless Steels, Austenitic (130-200 HB)
M.2 SS Stainless Steels, Austenitic, Hardened (150-230 HB)
M.3 SS Duplex
N.4 Copper, Brass, Zinc-based Alloys
H.1 Hardened Steels (44-48 HRC)
H.2 Hardened Steels (48-55 HRC)
Working Parameters
Select a machining / material combination to view the related working parameters. Experienced users can change the value of Vc within the defined range of values and the values of Ap and Ae.
Machining
Finishing
Material Table of Materials
P.3 Alloy Steels, Tool Steels (600-850 R N/mm²)
Axial depth of cut
Ap
Ap 0.07 mm
Radial depth of cut
Ae
Ae 0.15 mm
Cutting speed (130/180)
Vc
Parameters
Vc
fz [mm]
n [rpm]
F [mm/min]
Ap [mm]
Ae [mm]
Q [cm³/min]
Notes