Cutting parameters calculating

d

Diameter (mm) The minimum value is 0.01

z

Number of teeth (Nr.) The minimum value is 1

vc

Cutting speed (m/min) The minimum value is 1

n

Number of laps RPM (rpm) The minimum value is 1

fz

Feed per tooth (mm) The minimum value is 0.001

fn

Feed per lap (mm/rev) The minimum value is 0.01

vf

Feed (mm/min) The minimum value is 1

ap

Depth of cut (mm) The minimum value is 0.001

ae

Cutting width (mm) The minimum value is 0.01

q

Chip volume (cm³/min) This value is not changeable

hm

Average chip thickness (mm) This value is not changeable

b

Inclination (°) The minimum value is 0

deff

True diameter (mm) This value is not changeable

Cutting parameters calculator