Our attention is always focused on the
increase of our tools’ performances, particularly on the
research of a leadership in terms of productivity.
Our Research Center in Lanzo Torinese has developed this
tool, which has shown its high quality in the feeds and the
volumes of produced chips, in comparison with the best toric
or ball-nosed cutters available on the today market.
The range of diameters has been firmly increased through the
inclusion of the odd ones, that allow to use a tool, a
little inferior than the smaller radius expected in the
production process (e.g.using a 5 mm diameter instead of
a 4 mm diameter allow an increase of the chip volume of 40%
).
Documentation:
Movie: